Maintenance & Technical > KX500 Original
Complete KX500 top-end rebuild instruction here!
eprovenzano:
Can I safely assume, that the rebuild of the legendary KX500 would be similar to my KX250? I plan on doing a top end rebuild on my 99 KX250 in the early spring.
davidvak:
VERY IMPRESSIVE !!!!!!
THANKS A LOT !
raredesign:
I don't get the whole ballbearing idea for valve closing
redlined_KX500:
Those ball bearings go between end of KIPS actuating rod and end cap to control over rotation. I found mine at a bicycle shop. Can't remember exact size but it's listed in the thread for fixing that particular problem.
wreck-n-roll rik:
Great info and helped me alot tonight. Now tomorrow I'll have to put it back together after I clean it all up, found a leaky headgasket - Walls look good, piston good - have new rings and gaskets. Thanks, hope if I have problems getting it back togther you guys are around. :-D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version