Author Topic: Triming intake boot for spacer  (Read 1927 times)

0 Members and 1 Guest are viewing this topic.

Offline hughes

  • Hero Member
  • *****
  • Posts: 1,923
    • Dirt Hammers
Triming intake boot for spacer
« on: January 06, 2005, 11:57:12 AM »
Does anybody have a good pictures of their intake boot trimed and installed on the engine with the carb :?:  Left and right side pictures. I am making my own reed block spacer this week and just would like to see what the trimed intake boot will look like and how the carb throat fits into it. Thanks
Open Class 2-Stroke Kawasaki KX500
Yamaha 2005 YZ250
Richard Hughes
Dirt Hammers - Online Off-Road Journal
hughes@dirthammers.com
http://www.dirthammers.com

mikesmith

  • Guest
Triming intake boot for spacer
« Reply #1 on: January 07, 2005, 09:47:41 PM »
Just copy the gasket inside diameter to make a spacer,no need to trim the boot.You can even leave a lot of overhang on the out side if you feel lazy.The boot needs to be cut on the inside to run a V-fource,is that what you were thinking of maybe?

Offline hughes

  • Hero Member
  • *****
  • Posts: 1,923
    • Dirt Hammers
Triming intake boot for spacer
« Reply #2 on: January 08, 2005, 12:59:48 AM »
I guess there is enough movement in the air box boot to allow the carb to move back 10mm (spacer thicknest)
Open Class 2-Stroke Kawasaki KX500
Yamaha 2005 YZ250
Richard Hughes
Dirt Hammers - Online Off-Road Journal
hughes@dirthammers.com
http://www.dirthammers.com

mikesmith

  • Guest
Triming intake boot for spacer
« Reply #3 on: January 08, 2005, 09:54:02 PM »
Yes,just makes it that much tighter fit though!

Offline hughes

  • Hero Member
  • *****
  • Posts: 1,923
    • Dirt Hammers
Triming intake boot for spacer
« Reply #4 on: January 11, 2005, 11:06:21 AM »
Hey guy's check out the reed block spacer I made this week. All i need to do know is install and run. A.Hughes 87 KX500 gallery.
Open Class 2-Stroke Kawasaki KX500
Yamaha 2005 YZ250
Richard Hughes
Dirt Hammers - Online Off-Road Journal
hughes@dirthammers.com
http://www.dirthammers.com

Offline hughes

  • Hero Member
  • *****
  • Posts: 1,923
    • Dirt Hammers
Triming intake boot for spacer
« Reply #5 on: January 27, 2005, 10:55:25 AM »
Wow!! I just finally got to ride my 500 this afternoon for about three hours with the reed spacer I made. What a differance in low/mid power. This thing as better throttle responce through out the gear range. Seems like I have alittle more over rev. with out the engine breaking up. May jetting was o.k but now it seems to be right on the money. I was just alittle rich at idle to 1/4 throttle. Now it is spot on with the spacer. But may idle speed has increased just alittle with the spacer is this normal :?:
Open Class 2-Stroke Kawasaki KX500
Yamaha 2005 YZ250
Richard Hughes
Dirt Hammers - Online Off-Road Journal
hughes@dirthammers.com
http://www.dirthammers.com