Author Topic: Leaking clutch arm seal  (Read 1703 times)

0 Members and 1 Guest are viewing this topic.

Offline hughes

  • Hero Member
  • *****
  • Posts: 1,923
    • Dirt Hammers
Leaking clutch arm seal
« on: January 06, 2005, 12:47:32 PM »
My bike stayed on it left side for 2 days on a welding table while I repaired the pipe mount when I notcied that tranny oil was leaking out around the clutch arm. I am not getting water in the tranny. I change oil way to offen and inspect it and have found no water. I'm using bel ray gear saver 80wt. What color does ya'lls bel ray look after a couple of rides :?: . Mine looks almost purple with a gray tint . Does the chases have to be split to replace that clutch arm seal :?: Thanks dudes
Open Class 2-Stroke Kawasaki KX500
Yamaha 2005 YZ250
Richard Hughes
Dirt Hammers - Online Off-Road Journal
hughes@dirthammers.com
http://www.dirthammers.com

mikesmith

  • Guest
Leaking clutch arm seal
« Reply #1 on: January 07, 2005, 09:53:45 PM »
I havent had to change mine but if the cable is disconnected,you rotate the arm as you pull up and it comes out.The seal should just pop in and out.As far as tranny fluid color it depends on if you run steel or stock aluminum plates and the type of fiber plates you have and how much you use (slip) the clutch.

Offline hughes

  • Hero Member
  • *****
  • Posts: 1,923
    • Dirt Hammers
Leaking clutch arm seal
« Reply #2 on: January 09, 2005, 05:57:30 AM »
Thanks Dude,

I rotated and pulled the shaft up and then I use a srew driver to pop the seal out. Took a total of 5mins. for total replacement. Thanks
Open Class 2-Stroke Kawasaki KX500
Yamaha 2005 YZ250
Richard Hughes
Dirt Hammers - Online Off-Road Journal
hughes@dirthammers.com
http://www.dirthammers.com

Offline gowen

  • Resident Newbie
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1,350
  • www.KXRiders.com
Leaking clutch arm seal
« Reply #3 on: January 09, 2005, 04:14:42 PM »
Yeah, grey color is normal, the plates are usally aluminum and they just shed a storm in the oil. Pretty normal. Glad the repair was a simp. Let us know how the pipe mount repair goes.

Offline hughes

  • Hero Member
  • *****
  • Posts: 1,923
    • Dirt Hammers
Leaking clutch arm seal
« Reply #4 on: January 10, 2005, 11:32:09 AM »
I'll try here shortly to get some pic. I think the square stock is going to be strong.
Open Class 2-Stroke Kawasaki KX500
Yamaha 2005 YZ250
Richard Hughes
Dirt Hammers - Online Off-Road Journal
hughes@dirthammers.com
http://www.dirthammers.com