« previous next »
Pages: [1]   Go Down

Author Topic: piston rings  (Read 2759 times)

0 Members and 3 Guests are viewing this topic.

Offline gwcrim

  • Hero Member
  • *****
  • Posts: 673
    • http://profiles.yahoo.com/gwcrim
piston rings
« on: March 11, 2014, 12:56:00 PM »
I know this is a freshman question but I need an independent input.  Is there a top and a bottom to a piston ring on the 500?  I know on some rings there is a chamfer on the inner upper edge. 
Logged
~Crim~
You raise the blade
You make the change
You rearrange me 'til I'm sane

Offline Pmcg

  • Sr. Member
  • ****
  • Posts: 352
Re: piston rings
« Reply #1 on: March 11, 2014, 01:06:12 PM »
I always go writing side up.
Logged

Motorrad

  • Guest
Re: piston rings
« Reply #2 on: March 11, 2014, 02:51:18 PM »
Quote from: Pmcg on March 11, 2014, 01:06:12 PM
I always go writing side up.
Me to
Logged

Offline gwcrim

  • Hero Member
  • *****
  • Posts: 673
    • http://profiles.yahoo.com/gwcrim
Re: piston rings
« Reply #3 on: March 14, 2014, 09:01:08 AM »
All I can say is thanks.  I pulled the jug back off and sure as heck I had both of them upside down.  The top end had a few hours on it and you could barely see the letter L or K or whatever.  I should have known though as the top of each ring was notably darker than the bottom.
Logged
~Crim~
You raise the blade
You make the change
You rearrange me 'til I'm sane
Pages: [1]   Go Up
« previous next »