Author Topic: working on getting my bike tuned in..  (Read 8682 times)

0 Members and 1 Guest are viewing this topic.

Offline conbread

  • Full Member
  • ***
  • Posts: 97
Re: working on getting my bike tuned in..
« Reply #15 on: June 02, 2013, 02:40:21 PM »
well after reading up on crank seals.. with my jetting being so lean and the plug looking so black and feeling BLUBBERY for 1/2 throttle id say i prob need to pull it apart and replace them and the bearings....

Offline conbread

  • Full Member
  • ***
  • Posts: 97
Re: working on getting my bike tuned in..
« Reply #16 on: June 02, 2013, 02:43:49 PM »
any part numbers for a good set??

Motorrad

  • Guest
Re: working on getting my bike tuned in..
« Reply #17 on: June 02, 2013, 02:53:41 PM »
any part numbers for a good set??

cometic.

Offline conbread

  • Full Member
  • ***
  • Posts: 97
Re: working on getting my bike tuned in..
« Reply #18 on: June 02, 2013, 02:55:49 PM »
Motorrad whats your opinion on all this?
what about the bearings while i have it apart?

Offline Foxx4Beaver

  • Hero Member
  • *****
  • Posts: 8,952
  • James Stewart DID NOT invent the scrub!!..JoJo
Re: working on getting my bike tuned in..
« Reply #19 on: June 02, 2013, 02:56:38 PM »
OEM numbers are...

92045-1027 Crank bearings

92050-057 Seals

If you can afford it....you should just replace every bearing and seal while you're in there...then you know what you have,and should be good for quite a while.
Excuse me, ma'am...but you've got extremely nice legs!!!...what time do they open???                                                                                                               https://www.youtube.com/watch?v=n8tCgN3aryQ

Offline conbread

  • Full Member
  • ***
  • Posts: 97
Re: working on getting my bike tuned in..
« Reply #20 on: June 02, 2013, 03:03:24 PM »
yea i should have done it while i had the top end off lastweek, but hey this is still way cheaper than all of my turbo and blower mustang stuff.. hahahah

Motorrad

  • Guest
Re: working on getting my bike tuned in..
« Reply #21 on: June 02, 2013, 03:25:31 PM »
Motorrad whats your opinion on all this?
what about the bearings while i have it apart?

somone that reads my build thread more than I do should link over to the bearing section.   (sandblaster?)

I believe its in the first few pages?

Motorrad

  • Guest

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: working on getting my bike tuned in..
« Reply #23 on: June 02, 2013, 05:21:17 PM »
Sorry, I was enjoying a fire, friendship, and social lubricants.... Or I would have been happy to post the link...
Yes I read it a lot and learn something new every time,
Thanks Motorrad
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline conbread

  • Full Member
  • ***
  • Posts: 97
Re: working on getting my bike tuned in..
« Reply #24 on: June 03, 2013, 09:10:55 AM »
video is posted in the video section...