« previous next »
Pages: [1]   Go Down

Author Topic: shorty spark plug  (Read 5036 times)

0 Members and 2 Guests are viewing this topic.

Offline jrkawiracer

  • Jr. Member
  • **
  • Posts: 14
shorty spark plug
« on: April 14, 2011, 08:17:49 AM »
does anyone know the number of a shorty sparkplug, im building a AF 250 and the plug hits the tank just a little bit and want to run a short plug
Logged

Offline kxpegger

  • Hero Member
  • *****
  • Posts: 855
Re: shorty spark plug
« Reply #1 on: April 14, 2011, 09:44:52 AM »
This is the shorty in my 500AF:

BR8ECMIX

http://www.sparkplugs.com/
« Last Edit: April 14, 2011, 09:47:17 AM by kxpegger »
Logged
North Las Vegas

"05" RMZ450, "08" KX500AF "11" KTM 450SX-F "12" KTM 250SX "15" KTM450SX-F

Offline jrkawiracer

  • Jr. Member
  • **
  • Posts: 14
Re: shorty spark plug
« Reply #2 on: April 14, 2011, 01:57:30 PM »
does it give u good clearence at the tank??
Logged

Offline kxpegger

  • Hero Member
  • *****
  • Posts: 855
Re: shorty spark plug
« Reply #3 on: April 14, 2011, 02:49:53 PM »
With the stock tank there's good enough clearance to get the boot off and on but still a little tight. With the Clarke 3.2 gallon there's actually a lot more clearance and very easy to access the plug. My AF is an "08".
Logged
North Las Vegas

"05" RMZ450, "08" KX500AF "11" KTM 450SX-F "12" KTM 250SX "15" KTM450SX-F

Offline royceymon@hotmail.co.uk

  • Sr. Member
  • ****
  • Posts: 298
Re: shorty spark plug
« Reply #4 on: May 06, 2011, 10:30:05 AM »
try this r8 for max clearance !!!
Logged

Offline sylvester

  • Jr. Member
  • **
  • Posts: 45
Re: shorty spark plug
« Reply #5 on: May 06, 2011, 12:36:26 PM »
We warmed up the bulge in the tank with a heat gun (no open flame) and when it started to get soft, hold a wooden dowl against it just enough to clear. Allow it to cool and viola clearance. We just did this last night, search "juggernaut" here.
Logged

Offline LundMx

  • Full Member
  • ***
  • Posts: 113
Re: shorty spark plug
« Reply #6 on: April 19, 2013, 06:46:35 AM »
is there a part # for BR8ECMIX in non iridium?
Logged
LundMx
Pages: [1]   Go Up
« previous next »