« previous next »
Pages: [1]   Go Down

Author Topic: Cylinder Pictures  (Read 3329 times)

0 Members and 1 Guest are viewing this topic.

Offline 2-Stroke Tom

  • Full Member
  • ***
  • Posts: 160
Cylinder Pictures
« on: April 12, 2013, 06:53:53 AM »
Finally took my head off to have it sent to Larry Wiechman for his magic, and for the amount of use this bike now had, I think the cylinder looks pretty good. Also, looks like Team Green used sealant on the head gasket (I bet it's Hondabond HT), and what a mess it leaves. I might just used permatex copper spray, but what do you guys think? Go with the Hondabond HT again. I have the OEM steel had gasket (11004-1187, t = 0.2).



Logged

Offline Goat

  • Hero Member
  • *****
  • Posts: 785
  • Ride it like you stole it!
Re: Cylinder Pictures
« Reply #1 on: April 12, 2013, 07:02:01 AM »
Looks pretty good. I've had good luck with the copper spray. I try not to use hondabond on the head gasket. It tends to make the coolant passages smaller or over time goes through the cooling system and plugs up the radiator. With the heat the 500 makes that is a bad idea.
Logged
Quote from: Danger4u2 on June 17, 2010, 01:36:16 AM
It's hard to keep a drivers license riding a 2 stroke dirt bike on the street.  If you drive within the law they are VERY boring.

Motorrad

  • Guest
Re: Cylinder Pictures
« Reply #2 on: April 12, 2013, 11:01:15 AM »
Did ya get my PM tom?
Logged

Offline 2-Stroke Tom

  • Full Member
  • ***
  • Posts: 160
Re: Cylinder Pictures
« Reply #3 on: April 12, 2013, 11:27:47 AM »
Quote from: Motorrad on April 12, 2013, 11:01:15 AM
Did ya get my PM tom?
I did Motorrad. Thanks. Everything appears to be fine, but only time will tell!!
Logged

Offline 81cr450

  • Hero Member
  • *****
  • Posts: 887
Re: Cylinder Pictures
« Reply #4 on: April 12, 2013, 11:43:54 AM »
+1 on copper coat

Pioneer Brand if you can find it
Logged
if I only had a pair, I could actually ride this thing

& to the people I like  FYYFF
Pages: [1]   Go Up
« previous next »