« previous next »
Pages: [1]   Go Down

Author Topic: kll switch won't work on my 125  (Read 3683 times)

0 Members and 1 Guest are viewing this topic.

Offline jacob bo

  • Newbie
  • *
  • Posts: 9
kll switch won't work on my 125
« on: February 26, 2013, 10:48:10 AM »
My kill switch won't work on my 125. I've never had this happen on a bike before. Is it usually the button that goes out or the whole wire? Thanks in advance.
Logged

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: kll switch won't work on my 125
« Reply #1 on: February 26, 2013, 11:11:34 AM »
If you take it apart you should be able to see what the problem is.
Usually just corrosion or broken wire.
If you have an Ohm meter you should be able to trace it fairly easily.
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline jacob bo

  • Newbie
  • *
  • Posts: 9
Re: kll switch won't work on my 125
« Reply #2 on: February 26, 2013, 01:46:04 PM »
Thanks, as we say in Texas. ''I fitna fixit"!
Logged

Offline jacob bo

  • Newbie
  • *
  • Posts: 9
Re: kll switch won't work on my 125
« Reply #3 on: March 02, 2013, 02:19:16 AM »
I took it apart and didn't see any obvious signs of a problems on the wire. The I tried to clean around the button and it didn't work. I've got a new switch being shipped now. If that doesn't fix it what should I look at next. I cleaned the ground wires to the frame. Is it possible that the coil is going bad? I've never seen one go bad by not allowing the engine to stop but it wouldn't surprise me.
Logged

Offline jacob bo

  • Newbie
  • *
  • Posts: 9
Re: kll switch won't work on my 125
« Reply #4 on: March 04, 2013, 01:58:28 PM »
Ok guys I got the new kill switch and it fixed everything.
Logged

Offline USMC 500

  • Giant Member
  • Hero Member
  • *****
  • Posts: 1,026
  • Sikorsky CH-53E the KX500 of Marine Corps aviation
Re: kll switch won't work on my 125
« Reply #5 on: March 04, 2013, 02:30:45 PM »
Sorry you didn't get a response on that last post buddy.....I'm glad its fixed.

Next time to check to make sure 100% that the switch works is to get a multimeter, set it to ohms  and put each lead on each wire of the kill switch..

With the kill switch button NOT pressed you should have OL on the meter.....

With the kill switch button pressed you should get a very low resistance like 0.2 ohms.....

If you get OL when you press the kill switch button you know that the kill switch is not working correctly.
Logged
I once heard my buddy Bill ask Danny Hamel after a race....
"How can someone who looks like a high school band tuba player go so d**n fast on a bike?!"
Pages: [1]   Go Up
« previous next »