« previous next »
Pages: [1]   Go Down

Author Topic: 86 kx5 cylinder  (Read 2211 times)

0 Members and 1 Guest are viewing this topic.

Offline truckcap

  • Newbie
  • *
  • Posts: 6
86 kx5 cylinder
« on: March 16, 2012, 07:00:54 AM »
the 86 kx5 cylinder is not plated and therefore "bore-able" correct? just making sure before i start the rebuilding process . I have searched and i dont want to turn this into another plated vs sleeved debate, lol just looking for the original condition of the 86 cylinder. Thanks
Logged

Offline turdle

  • Full Member
  • ***
  • Posts: 104
Re: 86 kx5 cylinder
« Reply #1 on: March 16, 2012, 09:02:56 AM »
stock cylinder is NOT boreable, has to be replated!!
Logged

Offline cobbs

  • Full Member
  • ***
  • Posts: 103
Re: 86 kx5 cylinder
« Reply #2 on: March 16, 2012, 10:40:41 AM »
you can bore any cylinder doesn't matter if its plated or not if it is you need to either sleeve it or replate it but you can MOST DEFINENTLY bore your cylinder its just up to you if you want it sleeved or plated
Logged

Offline kwakman

  • Hero Member
  • *****
  • Posts: 879
  • Kwikasfuki KX500
Re: 86 kx5 cylinder
« Reply #3 on: March 17, 2012, 04:58:56 AM »
the 86 has a nikasil bore as standard, depends if someone has had it sleeved after.post up some pics looking at the top and bottom of your cyl, impossible to be certain without seeing it.K.
Logged
And lo, I did loft the front wheel and carried it forth to the unbelievers, and cast it down before them and said unto them ''look now upon the might of my throttle control ye pitiful cretinous ones''
And the unbelievers did quake in their boots....
Pages: [1]   Go Up
« previous next »