Well, I've been trying a veriety of mods to try to improve the green beast. I've finished the jetting, still needs work, but that is another story.
Today, I decided to install a Russell Front Brake Line that I had ordered a few weeks back, just to see if it improves the FRONT piece of s**t brake. I've had issues in the past with not having enough brakes in the front. So, I install them, bleed them until I nearly lose a can of brake fluid. Still spungy. I rebuilt my master cylinder last crash a few months back without luck. After trying to bleed the brake (did better with air in the line
), I decide I'm going out to the track to give it run. Works ok, nothing special or no improvement. I slam the table top and land fine, go to hit my brake and it just pulled in. So, I slam into the berm at 4th wfo, flip off the bike, which is fine thank God, get up and jump back on the bike and head to the truck. Look at my brake line and my friends, it slid in the holder (thingy that was holding it from moving while jumping), which I made sure was tight. Anyway, it slid out a little, destroyed the plastic outer layer and the braded wire, which punctured a hole in the line. The russell line is CR routing. Which I thought was cool, but in the long run, caused the line to grab the tire and brake disc.
That's all, I'm down $75 and bruised. Trying to keep my composure. I can't believe I could not get the line bled, it sucks. Not cause the russell brake line is a joke, but that I have to bleed the d**n old line now.
