« previous next »
Pages: [1]   Go Down

Author Topic: KX125/250 SWINGARM  (Read 1902 times)

0 Members and 2 Guests are viewing this topic.

Offline hillclimbjim

  • Jr. Member
  • **
  • Posts: 14
KX125/250 SWINGARM
« on: February 19, 2012, 03:43:49 AM »
is a 2001,125 swingarm the same as a 250 where the axel bolt and blocks are,the 125 is 55.78 mm.thanks
Logged

Offline sandblaster

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8,271
    • OEM-CYCLE QUALITY USED PARTS
Re: KX125/250 SWINGARM
« Reply #1 on: February 19, 2012, 02:49:57 PM »
Hello.
The Swing arm pivot pin and the shock arm linkage are the same for the 01 kx125 and 01 kx250.
They also use the same rear hub and rear axle.
The swing arms have different part numbers so my guess is that the 125 swing arm is probably a little shorter.
I have a 01 kx125 swing arm but I don't have one for the 250 to see the difference.
Logged
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.

Offline don46

  • Hero Member
  • *****
  • Posts: 1,140
Re: KX125/250 SWINGARM
« Reply #2 on: February 20, 2012, 02:58:32 AM »
as i recall the 250 swingarm was a bit longer than the 125, not huge but a bit. then again maybe i'm thinking 250f and 450f, the 450 is longer than the 250
Logged
Live today, for tomorrow may never come

Offline hillclimbjim

  • Jr. Member
  • **
  • Posts: 14
Re: KX125/250 SWINGARM
« Reply #3 on: February 20, 2012, 08:43:18 AM »
look to see if a set of hillclimb extentions from a 250 will bolt up to a 125,thanks for the help
Logged
Pages: [1]   Go Up
« previous next »